It is extremely important that DRI WASH 'n GUARD® be applied with the AIRosol sprayer only. Use on hard, non-porous surfaces only. Pre-test on inconspicuous area before use. Can be used over surface containing moderate level of dust, dirt, road grime or salt.
Refill Procedures:
- Unscrew collar nut at neck of AIRosol bottle and remove internal spray mechanism
- Invert bottle of product, shake vigorously for 15-20 seconds
- Pour contents into AIRosol bottle until 75% full
- Re-Install spray mechanism and collar nut
Directions By Hand:
Apply Dri Wash 'n Guard® to a cool, dry surface in a shaded area. Avoid windy conditions if possible.
Use two soft, clean terry cloth towels... one for cleaning/polishing and one for buffing.
Invert the bottle and shake vigorously for 15-20 seconds.
Pressurize the bottle by pumping the cap up and down until a strong resistance is felt (approx. 10-15 times).
Spray a generous coat of Dri Wash 'n Guard® on a small section of vehicle (2-3 sq. ft.), spraying with a broad sweeping motion where possible. On windows, apply a light coat.
With moderately firm pressure, rub DWG thoroughly over the sprayed area until the filmy haze that appears almost disappears.
Buff the remaining haze to a high gloss with second terry cloth towel
Directions by Machine:
Use a conventional or orbital-type buffer equipped with a foam polishing pad. Do not exceed 2,400 RPM.
Apply Dri Wash 'n Guard® as described in steps 3, 4, and 5 above.
Immediately buff sprayed area to a high gloss.
Continue, section by section, until all accessible areas have been buffed.
Polish any remaining areas by hand, if necessary.
For ultimate surface restoration, use DRI WASH 'n GUARD® Oxygone™ as Step 1, and DRI WASH 'n GUARD® Waterless Car Wash and Protective Glaze as Step 2.
Caution: Use under well ventilated conditions.
First Aid Treatment: If swallowed, call physician or poison control center immediately. Contains petroleum distillates.
