DriWash4Less
Product List
 
  Waterless Carwash
DWG Ultra-Ion 16oz
DWG Ultra-Ion 32oz
DWG Ultra-Ion 64oz
DWG Classic 32oz
DWG Classic 64oz

 
  Cleaning Treatments
DWG Fabric Treatment
DWG Leather Treatment
DWG Metal Treatment
DWG Tire Treatment
DWG Oxygone

 
  Kits
DWG Complete Detail Kit

 
DWG Microfiber Buffing
    Towels

DWG Pump Bottle
    (Airosol Applicator)


 

 
  Case Lots
Cases and Kits

 

 
 

INSTRUCTIONS

DRI WASH ‘n GUARD® ULTRA-ION™ Waterless Car Wash

It is extremely important that DRI WASH 'n GUARD® ULTRA-ION™ be applied with a DRI WASH 'n GUARD® Car AIRosol pump sprayer only.  Use on hard, non-porous surfaces only.  Pre-test on inconspicuous area before use.  Can be used over surface containing moderate level of dust, dirt, road grime or salt.

Refill Procedures:

  1. Unscrew collar nut at neck f AIRosol pump sprayer and remove internal spray mechanism
  2. Invert bottle of product, shake vigorously for 15-20 seconds
  3. Pour contents into AIRosol pump sprayer until 75% full
  4. Re-Install spray mechanism and collar nut

 

Directions By Hand:

Apply Dri Wash 'n Guard® ULTRA-ION™ to a cool, dry surface in a shaded area.  Avoid windy conditions if possible.

Use two soft, clean terry cloth towels... one for applying the product and one for buffing.  For best results, use the DWG Buffing Towel for buffing.

Invert the AIRosol pump sprayer and shake vigorously for 15-20 seconds.

Pressurize the bottle by pumping the cap "up and down" until a strong resistance is felt (approx. 10-15 times).

Spray a light coat of Dri Wash 'n Guard® ULTRA-ION™ on a small section of vehicle (2-3 sq. ft.), spraying with a broad sweeping motion where possible.

Using the terry cloth towel, with moderately firm pressure, rub polish thoroughly over the sprayed area until the filmy haze that developed almost disappears.

Buff the remaining haze to a high gloss with the DWG buffing towel

 

Directions by Machine (FOR PROFESSIONALS ONLY):

Use a conventional or orbital-type buffer equipped with a foam polishing pad.  Do not exceed 1,500 RPM.

Apply Dri Wash 'n Guard® ULTRA-ION™ as described in steps 3, 4, and 5 above.

Immediately buff sprayed area to a high gloss.

Continue, section by section, until all accessible areas have been buffed.

Polish any remaining areas by hand, if necessary.

For ultimate surface restoration, use DRI WASH 'n GUARD® Oxygone™ as Step 1, and DRI WASH 'n GUARD® ULTRA-ION™ Waterless Car Wash and Protective Glaze as Step 2.

 

Caution: Use under well ventilated conditions.  Prevent product from freezing.  DO NOT MIX THIS PRODUCT WITH ANY OTHER CHEMICAL OR WATER.

First Aid Treatment: If swallowed, call physician or poison control center immediately.  Contains petroleum distillates.


Terms of Use        Privacy Policy

Tb14